Viatron AA800EZe Manuel d'utilisateur Page 12
- Page / 32
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
12
AA800EZe rev.04
AA800EZe
3.6. Speakers
When an alarm condition is validated, an
alarm message is immediately delivered
through the unit speaker. You can adjust the
volume of the system’s voice and can turn the
speaker on or off. By default, the mute func-
tion is disabled and the speaker enabled.
Select:1.
• Main Menu
• System Auxiliaries
• User Preferences
• Voice Volume
Voice Volume
Speaker Volume 50
Mute Voice No
Back
Set the following parameters:2.
Speaker Volume — Set the speaker volume
to the desired intensity.
Mute Voice — Select “Yes” to mute the sys-
tem’s voice or select “No” to allow spoken
message to be delivered through the speaker.
If an alarm situation occurs while the voice is
mute, the system sends out an alarm sound
instead of a vocal message.
3.7. Configuring the Zones
Introduction3.7.1.
The Agri-Alert system is a device used to de-
tect alarm conditions. It can monitor several
types of sensors and can launch a dialout
sequence each time an alarm is detected on
one of its inputs.
When an alarm is detected, the system re-
ports the alarm on-site and starts the dialout
sequence. It maintains the alarm active up
until a user acknowledges it, either on-site
or on the phone. In addition, the Agri-Alert
stores all relevant information regarding
the incident: the zone number, the type of
alarm, the moment at which it occurred/was
acknowledged and the identity of the user
who has acknowledged it.
Zone Definition:
A zone is an input configured to respond to
the type of sensor connected to it. In all, the
Agri-Alert can monitor 8 different zones on
which dry contact, dry contact burglar, or
temperature sensors can be connected.
Note that when you reconfigure a zone,
the system automatically deactivates
this zone input. Refer to section 3.7.8
to reactivate it.
3.7.2. Number of Zones & Outside
T° Sensor
The Agri-Alert can monitor up to 8 different
zone inputs and 1 outside temperature sen-
sor. This section explains how to activate
these inputs.
Select:1.
• Main Menu
• Install Programming*
• Program Zones
* Accessible with the Installer or Master password
only (see section 3.2).
Zone Installation
How many zones ? 8
Use Outdoor T° No
Back
Set the following parameters:2.
How ma ny z on e s ? — Select how many zones
are required (from 1 to 8 zones).
Use Outdoor Temperature Sensor ? — Select
“Yes” if an ou t si d e te m pe r at u re s e ns o r is co n -
nected to the Agri-Alert.
- Agri-Alert 800EZe 1
- 10ft (3m) 6
- AA800EZe 10
Sma SMC 4600A Installation podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Ekwipunek Sma SMC 4600A Installation.
Dostarczamy 4 pdf podręczników Sma SMC 4600A Installation do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Commentaires sur ces manuels